May 11, 2020
Hi from sunny Lytham Lancashire. I have a D7 Bantam that is in roughly trials spec. I could do with knowing what frame, hubs and forks they are so i can get the right parts.
I believe the forks are C15 but not 100%. The stem is too long by about 25mm do you normally cut these down and use same headrace.
Any more advice welcome.
November 16, 2011
** Please log in to view **
Hopefully the engine & frame numbers are still in place....all will be revealed on receipt of those 🙂
I have a VERY rough D5 project in the pipeline(they were only produced for one year), nowhere near as nice as yours, and it has B175 or other heavyweight forks fitted. It`s currently 6 bikes deep into the lockup, but one fine week I`ll dig it out....
If yours isn`t a D5, then it`s the D3 swing-arm model.....going by the limited view I can get from your photo. Unless someone`s grafted an early subframe onto a later Bantam frame, which is unlikely.
May 11, 2020
June 2, 2017
Most Users Ever Online: 223
Currently Online: sunny, cocorico, Pootle, N.D.James, SuperSun64
Currently Browsing this Page:
Cornish Rooster: 3310
Blue Heeler: 2703
Sprung Chicken: 2653
David Dale: 2484
Mags 1: 2335
Guest Posters: 1477
Administrators: Bantam-Super, JMD, Springs, Stoo63