May 22, 2019
My 65 D7 Trail Bronc has the usual clipped rear fender, right at the riveted fender stay band. I found a that a 71 Triumph 250 front fender is the same "D" profile, and ~ 4 " wide. I have one in hand, ready to donate to the cause! Before I attempt the surgery, I need some info:
1) what is the measurement from the fender "tip" to the center of the riveted fender stay band?
2) can someone post a picture of the end of the fender? is it a rolled edge or a straight cut?
3) For 65, Sapphire blue is the same as the bronc "Nutley Blue" (for nutley NJ bikes.) does someone have a standard US paint code that matches?
Mike the Shopguy. Head muckety-muck of FBM Engineering; making rolling oddities and noise generators from otherwise normal stuff
November 6, 2016
The distance from the bottom of the stay support strap to the bottom tip of the fender is 9 inches.
The fender also has four holes pre-drilled to accept a rear light fitting.
I took the measurements from a genuine original TB rear fender.
I will try to get a photograph but is not always easy at this time of year.
Most Users Ever Online: 223
Currently Online: Piquet, cocorico, Mick W, Maico490, Wellman1
Currently Browsing this Page:
Cornish Rooster: 3314
Sprung Chicken: 2651
Mags 1: 2612
David Dale: 2485
Blue Heeler: 2138
Guest Posters: 518
Administrators: Piquet, JMD, Rusty Floater
Moderators: xcgb, Mick W, Stoo63